AMERICA'S MOST AFFORDABLE POWERSPORTS & ALL TERRAIN VEHICLE DEALER SINCE 2004

How to Change the Oil in a Kids ATV

Introduction

Changing the oil in a gas powered kids ATV is an essential maintenance task that ensures the longevity and optimal performance of the vehicle. By following a few simple steps, you can easily change the oil yourself, saving time and money. In this article, we will guide you through the process of changing the oil in a kids ATV.

Step 1: Gather the Necessary Tools and Materials

Before you begin, make sure you have the following tools and materials:

  • Socket wrench set
  • Oil filter wrench
  • Drain pan
  • New oil filter
  • New engine oil
  • Clean rags

Step 2: Locate the Oil Drain Plug

Start by locating the oil drain plug on your kids ATV. It is typically located on the bottom of the engine. Refer to the owner's manual for the exact location if you are unsure.

Step 3: Drain the Old Oil

Place the drain pan underneath the oil drain plug to catch the old oil. Using the socket wrench, carefully loosen the drain plug and let the oil drain completely into the pan. Once the oil has drained, securely tighten the drain plug.

Step 4: Replace the Oil Filter

Locate the oil filter on your kids ATV. Using the oil filter wrench, carefully remove the old oil filter. Make sure to clean any oil residue from the filter mounting surface. Apply a thin layer of new oil to the rubber gasket of the new oil filter. Install the new oil filter by hand and then tighten it with the oil filter wrench until it is snug.

Step 5: Refill with New Oil

Refer to the owner's manual to determine the correct type and amount of oil needed for your kids ATV. Remove the oil fill cap and pour the new oil into the engine. Use a funnel to avoid spills. Once the oil is filled to the recommended level, securely replace the oil fill cap.

Step 6: Clean Up and Dispose of the Old Oil

Dispose of the old oil responsibly by taking it to a local recycling center or an auto parts store that accepts used oil. Make sure to clean up any spills or drips with a clean rag.

Step 7: Check Oil Level

After changing the oil, start the engine and let it run for a few minutes. Turn off the engine and allow it to sit for a few minutes. Remove the oil dipstick, wipe it clean, and reinsert it. Remove the dipstick again and check the oil level. The oil should be between the minimum and maximum marks on the dipstick. If the level is low, add more oil as needed.

Step 8: Schedule Regular Oil Changes

Changing the oil in your kids ATV should be done at regular intervals to ensure optimal performance. Refer to the owner's manual for the recommended oil change frequency. Regular oil changes will help maintain the engine's health and extend the life of the vehicle.

Conclusion

Regularly changing the oil in your kids ATV is crucial for maintaining its performance and extending its lifespan. By following the steps outlined in this article, you can easily change the oil yourself. Remember to consult the owner's manual for any specific instructions related to your ATV model. Taking the time to properly maintain your kids ATV will not only save you money on repairs but also provide a safe and enjoyable riding experience for your child. Happy riding!


Leave a comment

Please note, comments must be approved before they are published